云南腾冲科学钻探废弃钻井液固化处理技术研究 |
投稿时间:2013-07-17 修订日期:2013-07-17 点此下载全文 |
引用本文:卢予北,范晓远,吴烨,等.云南腾冲科学钻探废弃钻井液固化处理技术研究[J].钻探工程,2013,40(8):14-17.LU Yu-bei,FAN Xiao-yuan,WU Ye,et al. Research on Waste Drilling Fluid Solidification Technology of Tengchong Scientific Drilling in Yunnan[J]. Drilling Engineering, 2013,40(8):14-17. |
摘要点击次数: 1080 |
全文下载次数: 816 |
|
基金项目:国家科技专项“深部探测技术与实验”—SinoProbe-05“大陆科学钻探选址与钻探实验”资助 |
|
中文摘要:根据云南腾冲科学钻探废弃钻井液的特点,确定了先絮凝破胶再固化的技术路线,筛选出絮凝破胶预处理及固化的最优配方。实验结果表明,固化效果良好,经絮凝沉降后分离出的废水、固化物浸出液污染物含量均达到污水综合排放一级标准。 |
中文关键词:科学钻探 废弃钻井液 絮凝 固化 腾冲 |
|
Research on Waste Drilling Fluid Solidification Technology of Tengchong Scientific Drilling in Yunnan |
|
|
Abstract:According to the characteristics of waste drilling fluids of Tenchong scientific drilling project in Yunnan, the technology route of first flocculation and gel breaking then consolidation was determined, the optimal formula of flocculation and gel breaking pretreatment and solidification were screened out. The experimental results show that the solidification effects are good, the pollutnats contant in the separated waste water after flocculation sedimentation and leaching solution of cured resin meet the 1st grade integrated wasterwater discharge standared. |
keywords:scientific drilling waste drilling fluid flocculation consolidification Tengchong |
查看全文 查看/发表评论 下载PDF阅读器 |