一种大直径反井钻杆接头螺纹参数的优化研究 |
投稿时间:2014-07-11 修订日期:2014-08-08 点此下载全文 |
引用本文:赵小军,赵钧羡,陈锡庆,等.一种大直径反井钻杆接头螺纹参数的优化研究[J].钻探工程,2014,41(10):67-71.Zhao Xiaojun,ZHAO Jun-xian,CHEN Xi-qing,et al. Optimal research on the joint thread parameters of a kind of large-diameter drill rod[J]. Drilling Engineering, 2014,41(10):67-71. |
摘要点击次数: 875 |
全文下载次数: 615 |
|
基金项目:江苏省重大科技成果转化项目“矿用大直径硬岩钻进钻具的国际合作研究及产业化”(BA2013014) |
|
中文摘要:采用有限元分析和正交试验相结合的方法对反井钻井用大直径钻杆的接头螺纹参数进行了优化研究。研究结果表明,外螺纹小端大径、锥度、牙侧角和锥部长度等参数对接头螺纹强度有显著影响,得到了各参数作用的主次顺序和不考虑交互作用条件下各参数的最优值。 |
中文关键词:大直径反井钻杆 有限元分析 正交试验 接头螺纹参数 优化研究 |
|
Optimal research on the joint thread parameters of a kind of large-diameter drill rod |
|
|
Abstract:The optimization study on parameters of a large diameter drill pipe joint thread used in mine shaft rising boring is conducted through combining the orthogonal experiment with the finite element theory in this paper. The study results show that small end outer diameter of the screw thread, the taper, side angle of the thread and length of the screw thread etc. have a significant impact on the strength of the thread, the significance order of these parameters on the thread strength and the optimal value of the thread without considering the interaction of these parameters are obtained. |
keywords:large-diameter inverse well drill pipe finite element analysis orthogonal experiment joint thread optimization |
查看全文 查看/发表评论 下载PDF阅读器 |