扭力冲击器复合钻进工艺在干热岩钻井中的试验应用
投稿时间:2022-07-21  修订日期:2022-09-26  点此下载全文
引用本文:谭现锋,战启帅,张强,等.扭力冲击器复合钻进工艺在干热岩钻井中的试验应用[J].钻探工程,2023,50(1):94-101.
TAN Xianfeng,ZHAN Qishuai,ZHANG Qiang,et al. Test of compound drilling with the torsional impactor in hot dry rock geothermal wells[J]. Drilling Engineering, 2023,50(1):94-101.
摘要点击次数: 569
全文下载次数: 514
作者单位E-mail
谭现锋 山东省鲁南地质工程勘察院(山东省地质矿产勘查开发局第二地质大队)山东 济宁 272100
山东省地热清洁能源勘查开发工程研究中心山东 济宁 272100 
geotan1977@126.com 
战启帅* 山东省鲁南地质工程勘察院(山东省地质矿产勘查开发局第二地质大队)山东 济宁 272100
山东省地热清洁能源勘查开发工程研究中心山东 济宁 272100 
zhanxingzhe@126.com 
张强 山东省鲁南地质工程勘察院(山东省地质矿产勘查开发局第二地质大队)山东 济宁 272100
山东省地热清洁能源勘查开发工程研究中心山东 济宁 272100 
 
王勇军 山东省地质矿产勘查开发局第二水文地质工程地质大队(山东省鲁北地质工程勘察院)山东 德州 253072  
赵长亮 山东省地质矿产勘查开发局第二水文地质工程地质大队(山东省鲁北地质工程勘察院)山东 德州 253072  
李生海 山东省鲁南地质工程勘察院(山东省地质矿产勘查开发局第二地质大队)山东 济宁 272100
山东省地热清洁能源勘查开发工程研究中心山东 济宁 272100 
 
陈宗涛 湖北工程学院机械工程学院湖北 孝感 432000  
中文摘要:扭力冲击器在石油、天然气行业钻井中得到广泛应用,具有提速增效的作用。而干热岩钻井工作环境不同于油气钻井,面临着高温、高压、硬岩、强研麿性以及深井、超深井等问题,因此对扭力冲击器进行了针对性设计,并进行试验应用。在扭力冲击器2次入井试验中,对硬-极硬岩地层进行了不同钻具组合下的钻进试验,确定了扭力冲击器对钻进效率的影响机理。结果表明:(1)扭力冲击器能够消除螺杆钻具因离心惯性力造成钻具的横向振动,验证了扭力冲击器与螺杆钻具组合应用的可行性。相比未使用扭力冲击器井段,机械钻速提高29.59%。(2)从碎岩机理和地层适配性上,相比PDC钻头,牙轮钻头在扭力冲击器+螺杆钻具+转盘复合钻进的方式下,有着较高的钻进优势。试验成果可为扭力冲击器与牙轮钻头匹配性研究和扭力冲击器与螺杆钻具的耦合性研究提供较好的技术基础。
中文关键词:扭力冲击器  复合钻进工艺  干热岩钻井  钻进效率
 
Test of compound drilling with the torsional impactor in hot dry rock geothermal wells
Abstract:The torsional impactor which can increase drilling rate and efficieny has seen wide use in oil and gas drilling industry. But hot dry rock drilling is quite different, where many difficulties such as high temperature, high pressure,hard rock, strong abrasiveness,deep and ultra-deep wells, are encountered. Specific design has been made on the torsional impactor in regard to these issues and trial use was conducted. A series of drilling tests were conducted on the torsional impactor with different drilling tool combinations in hard-extremely hard rock strata during two drilling trips to study its influence on drilling efficiency.The test results show that the torsional impactor can eliminate the lateral vibration of PDM caused by centrifugal inertia force, which verifies the feasibility of the combined application of the torsional impactor and PDM. ROP increased by 29.59% from the well section where the torsional impactor was not used.In addition, the roller cone bit had higher drilling advantages over the PDC bit in the combined drilling mode of the torsional impactor+PDM+the rotary table in terms of the rock fragmentation mechanism and the formation adaptability. The test results can provide theoretical basis for both the study of the matching between the torsional impactor and the cone bit and that for the coupling between the torsional impactor and PDM.
keywords:torsional impactor  compound drilling  dry hot rock drilling  drilling efficiency
查看全文  查看/发表评论  下载PDF阅读器