云南腾冲科学钻探废弃钻井液固化处理技术研究
DOI:
作者:
作者单位:

河南省深部探矿工程技术研究中心,河南省工程学院,河南省工程学院,河南省工程学院

作者简介:

通讯作者:

中图分类号:

P634.6

基金项目:

国家科技专项“深部探测技术与实验”—SinoProbe-05“大陆科学钻探选址与钻探实验”资助


Research on Waste Drilling Fluid Solidification Technology of Tengchong Scientific Drilling in Yunnan
Author:
Affiliation:

Henan Engineering Research Center of Depth Exploration,Henan Institute of Engineering,Henan Institute of Engineering,Henan Institute of Engineering

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    根据云南腾冲科学钻探废弃钻井液的特点,确定了先絮凝破胶再固化的技术路线,筛选出絮凝破胶预处理及固化的最优配方。实验结果表明,固化效果良好,经絮凝沉降后分离出的废水、固化物浸出液污染物含量均达到污水综合排放一级标准。

    Abstract:

    According to the characteristics of waste drilling fluids of Tenchong scientific drilling project in Yunnan, the technology route of first flocculation and gel breaking then consolidation was determined, the optimal formula of flocculation and gel breaking pretreatment and solidification were screened out. The experimental results show that the solidification effects are good, the pollutnats contant in the separated waste water after flocculation sedimentation and leaching solution of cured resin meet the 1st grade integrated wasterwater discharge standared.

    参考文献
    相似文献
    引证文献
引用本文

卢予北,范晓远,吴烨,等.云南腾冲科学钻探废弃钻井液固化处理技术研究[J].钻探工程,2013,40(8):14-17.
LU Yu-bei, FAN Xiao-yuan, WU Ye, et al. Research on Waste Drilling Fluid Solidification Technology of Tengchong Scientific Drilling in Yunnan[J]. Drilling Engineering, 2013,40(8):14-17.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2013-07-17
  • 最后修改日期:2013-07-17
  • 录用日期:2013-07-23
  • 在线发布日期: 2013-09-03
  • 出版日期: